Chamber Upload Stream

BERETTA 80 SERIES // how to field strip the Beretta 84 Cheetah or Beretta 85 Cheetah

Published on Feb 1, 2021
Did you get a Beretta that looks like the 92 or M9 but it is just a little smaller and in 380 or 32? You purchased a Beretta 80 Series! This video features a Beretta 85 but the field strip is the same across all 80 series (84 and 81).

There are only a few differences between the few models of the Cheetah (Beretta 81, Beretta 84 and the Beretta 85). The Beretta 82 is identical to the Beretta 84 except that it is chambered in .32 ACP instead of .380 ACP. While the Beretta 85 is similar to the Beretta 84 in the fact that it is chambered in .380 ACP, it has a single stack magazine making it slightly thinner. Those with smaller hands and/or doing concealed carry typically choose the Beretta 84 over the Beretta 84.

Video Index:
Intro - 0:00
What is the difference between the Beretta 84 and Beretta 85 - 00:14
How to lock the slide back to the rear on a Beretta 84 or Beretta 85 - 00:30
How to remove the slide on the Beretta 84 or Beretta 85 - 00:35
How to remove the barrel on the Beretta 84 or Beretta 85 - 00:58
How to install the barrel on the Beretta 84 or Beretta 85 - 01:37
How to install the slide on the Beretta 84 or Beretta 85 - 02:37
How to safely decock the hammer on the Beretta 84 or Beretta 85 - 03:26
How to support us:
Shopping our Affiliate links and banners on

A full list of our Affiliate partners (support us for free by clicking these links before you shop) or

Support this channel on Patreon

Support this channel on Subscribestar

Social Media
Visit us on Instagram

Visit us on Facebook

Equipment I use
Computer -
Video editing software -
Picture editing software -
Video Camera - (yes this what I really use for my studio filming)
Still Camera - (also does my outdoor filming)
Camera external mic -
Voice Over Mic -
White Balance Card -
Studio Lighting -
Green Screen -
New microphone I am testing with -

Camera/mic stand and conversion parts to make it all work
Camera/Voice Over Mic stand -
Camera Adapter
Cellphone holder

My 3d Printer setup
Ender 3 with glass bed -
Raspberry PI for Octoprint -
Storage for Raspberry PI -
Camera for time-lapse -
Livestream camera (yea I know it is old) -
PLA+ Filament (my go to filament) -
ABS Filament -
Upgraded bed springs -
Upgraded hotend -

The products (videos, articles, pictures. Etc.) available through The Rogue Banshee (including gear, tools, products, etc. that are featured, seen or used) are for informational and entertainment purposes only. The opinions expressed through our content are that of the individual author.

Affiliate Disclaimer: Most of the Amazon and TRB Gear links above are affiliate links! We earn a VERY small sales commission percentage of purchases (if generated by clicking the links above).

Using our Affiliate links above or on our webpage helps us bring new content and will cost you nothing above what you would have already spent if not using them. We maintain Affiliate associations with several vendors, including Amazon and Brownells.


Share Video

  • 560 x 315
  • 640 x 360
  • 853 x 480
  • 1280 x 720

Add to

Flag Video

Rate video

Rate video

Up next