1911 Slide Blending // Get A Custom Fit And Finish, Now!
Published on Jul 3, 2021
Most stock (mass-produced) 1911s have a terrible fit and finish. In this video, I show you how to smooth out the rear of the slide so that you don't cut your hands or snag your clothing.
This process is what a custom 1911 makes does to give a nice finish to the firearm. Now you can get the same results on either you stock gun or your custom 1911 that you may be building.
*** You can support our work by ***
♦ Shop our Amazon Store: https://www.amazon.com/shop/theroguebanshee
♦ Check out our MERCH Store: https://bit.ly/2SpVCj3
♦ Become a Member of #TeamBansh here: https://bit.ly/3cQQYzo
♦ TRB AFFILIATES AND DISCOUNT CODES: https://linktr.ee/theroguebanshee
Intro - 0:00
Tools and Safety information - 0:11
Leveling the rear of the slide to the 1911 frame - 0:53
Getting the tight areas smoothed out on the 1911 - 2:23
Removing file marks and final contouring of the 1911 slide - 3:22
Final thoughts on the 1911 slid to frame contour - 3:24
Gear that I run
Camera and Mic
My 3d Printer setup
The Rogue Banshee Original Content
Credit: Jason Schaller
The products (videos, articles, pictures. etc.) available through The Rogue Banshee (including gear, tools, products, etc. that are featured, seen or used) are for informational and entertainment purposes only. All activities are completed in accordance with all local, state and federal regulations, as well as in a safe manner in approved locations with professional supervision.
Affiliate Disclaimer: In accordance with the rules and regulations set by the FTC, The Rogue Banshee is an affiliate marketer for several companies.
- Your Subscription
- TheRogueBanshee -